PRODUCT DESCRIPTION
CircuitWorks
Conductive Pen makes
instant highly conductive silver traces on
circuit boards. CW2200 is used in
prototype, rework, and repair of circuit
boards by linking components, repairing
defective traces, and making smooth
jumpers. The silver traces dry in minutes
and have excellent adhesion to most
electronic materials. Engineers, repair
technicians, and manufacturers will find that
the CircuitWorks
Conductive Pen speeds
project completion and cuts rework time.
Single component system
High electrical conductivity
Fast drying
Highly adherent to circuit boards
Operating temperature to 400°F (205°C)
TYPICAL APPLICATIONS
CircuitWorks
Conductive Pen may be used
for electronics applications including:
Circuit Trace Repair
Solderless Linking of Components
EMI Shielding
Solderable Terminations
Quick Prototype Modifications
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
Material Silver Filled Polymer
Conductivity 0.02-0.05 ohms/sq/mil
0.00005-0.000125 ohm cm
°
°
Tack-Free Time @ 25°C 3 to 5 Minutes
Cure Time @ 25°C 20 to 30 Minutes
Solder Wetting 2 to 3 Seconds
Electrical Conductivity Excellent
Tip Diameters
MTP 0.8 mm (0.03 inches)
COMPATIBILITY
CircuitWorks
Conductive Pen material has
excellent compatibility with materials used
in printed circuit board fabrication. As with
any chemical system, compatibility with the
substrate must be determined on a non-
critical area prior to use.
TDS # CW2200
Technical Data Sheet
CircuitWorks
Conductive Pen
Kommentare zu diesen Handbüchern